Removable Folding Sliding Door Partitions Sound Proof Acoustic Partition Walls for Office
Acoustic partition walls operation
1. If there is a door in the acoustic partition walls panels, first turn the square hole on both sides of the door to rotate 180 degrees, loosen the upper and lower seals through the transmission wheel, and then close the door in the door;
2. Ppen the last screen of the telescopic aluminum plate and the upper and lower seals;
3. Retract the telescopic aluminum plate of the last screen so that its distance can at least turn the distance of the screen, generally about 140mm;
4. Push the panel to the position of the acoustic partition walls in the direction of the track.
5. After each group of screens is collected in the same way, press each two screens tightly to minimize the distance between the screens and the screens. If necessary, you can open the up and down motion seals of the last screen that is housed at the hidden plate so that it presses against the rails and the ground. This will prevent others from easily pulling the screen out.
Acoustic partition walls details
The acoustic partition wall is a kind of operable wall that can divide a large space into a small space or a small space into a large space at any time according to needs and has a general wall function. It can serve as a multi-purpose room with multiple functions.
The acoustic partition has the characteristics of easy installation, reliability, industrial production, fire prevention, and environmental protection.
When the operable seals are retracted, acoustic partition walls panels glide effortlessly and quietly along the unique aluminium overhead track system (no need for floor guide).
Telescopic end panels enable the acoustic partition wall to be locked off to complete the acoustic seal. The track and carrier system provides ease of operation and directional flexibility, allowing panel stacking in countless configurations.
At present, acoustic partition walls and fixed partition series products are widely used in hotels, hotels, multi-purpose halls, conference rooms, banquet halls, office buildings, exhibition halls, financial institutions, government offices, hospitals, factories and other occasions.
Technical information
| Model | BG65 | BG85 | BG100 |
| Suspension System | Hanging System, with ceiling rails |
| Basic Thickness | 65mm | 85mm | 100mm |
| Max Height | Max 3800mm | Max 6000mm | Max 8000mm |
| Width | 800 -1230mm |
Floor/ceiling Sealing
strength | Telescopic aluminum tube with rubber strip |
Side Walls Sealing
Strength | Double seal tape |
| Base Board Thickness | 9 mm | 9 mm | 12 mm |
| Vertical Profiles | Aluminum anodised with sealing profiles |
| Retractable Seals | Aluminum black with double rubber seals |
| Operation | Manual System, with supplied operating handle |
| Pass Doors | Single or Double Pass Through Door Available |
| Weight | Approx 22-35 kg/m² | Approx 25-40 kg/m² | Approx30-48 kg/m² |
| Finish Options | Plywood, MDF, Laminate, Melamine, Gypsum board, Fabric, Leather, Insulation board, Fireproof board, Wall paper, Vinyl, Painting, etc. (Customized) |
Acoustic partition walls installation
1. Remember that the acoustic partition walls track should be loose enough above all the brackets to ensure that the track is paused;
2. After the track of the acoustic partition walls is laid, tighten the connection of all the tracks and adjust the horizontal level of the track correctly. The direction of the track installation must also be horizontal and straight;
3. When the acoustic partition walls track facility is installed, the sound insulation and mineral wool are the necessary plates for installation;
4. Before closing the acoustic partition walls, the height of the carrier must be adjusted, and the straight angle of the track should be checked to make the track partition work well;
5. Check all acoustic partition walls, whether they are all vertical, if there is no damage, you can enter the edge of the aluminum frame of the rubber seal vertically and not bend;
If the orbital direction is horizontal, but the active partition is suspended, then the carrier height must be adjusted.
